Basic Flow Of Scanning Operation - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 1 Scanner Overview

1.9 Basic Flow of Scanning Operation

This section explains about the basic flow of performing a
scan.
In order to perform a scan, you need a scanner driver and an
application that supports the scanner driver.
This product bundles the TWAIN driver and the ISIS driver
(compliant to the respective standards), Kofax VRS, and an
application called "ScandAll PRO" which supports both drivers
and Kofax VRS.
For details about the scanner drivers, refer to:
- "Chapter 3 Configuring the Scan Settings" (page 51)
- TWAIN driver Help
- ISIS driver Help
For details about Kofax VRS, refer to:
- Kofax VRS Help
For details about ScandAll PRO, refer to:
- ScandAll PRO V2.0 User's Guide
- ScandAll PRO Help
The following describes the normal procedure for scanning.
1
Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2
Load a document face-down in the ADF paper chute.
For details, refer to "Chapter 2 How to Load Documents" (page
TOP
Contents
Index
Introduction
Scanner
Overview
23).
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
37).
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
32