Scanning Does Not Start - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 8 Troubleshooting

Scanning does not start.

Did you unlock the transport lock switch?
(fi-6230Z/fi-6240Z)
Yes
Is the document loaded in the ADF paper chute correctly?
Yes
Is the ADF closed properly?
Yes
Is the USB/SCSI cable connected properly?
Yes
Is the connector on the USB/SCSI cable broken or
damaged?
No
Is the SCSI ID set correctly?
(For SCSI connection)
Yes
Does scanning start after turning the scanner off then back
on?
No
Turn off the scanner, and unlock the transport lock switch.
For details, refer to "Installing the Scanner" in Getting Started.
No
Reload the document in the ADF paper chute.
No
Remove the documents from the ADF paper chute, then open and close the ADF.
No
Connect the USB/SCSI cable properly.
For details, refer to "Connecting the Cables" in Getting Started.
No
Use a new cable and make sure that it is connected properly.
Yes
Turn off the scanner and the computer, and configure the correct SCSI ID. Then
restart the computer after turning the scanner back on.
No
For details about the SCSI ID setting, refer to "Connecting the Cables" in Getting
Started.
The scanner is operating correctly.
Yes
If the problem persists, check the items in
Service Provider" (page 149)
an authorized FUJITSU scanner service provider.
"8.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
133