Troubleshooting - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Glossary
Patch code
A special code to let the scanner recognize the start and the end of each job or image mode.
Pick roller
A set of rollers which separates one sheet off the documents loaded in the ADF paper chute, and feeds the document into
the ADF.
Pick start time
The period of time between setting the document and until picking starts after the document passes the hopper empty
sensor.
Pixel
The dots that make up a scanned image.
Portrait
Orientation in which the long side of the document is set parallel to the feed direction. Documents/images are set/displayed
vertically.
Pre-pick
Refers to feeding the document in advance to the position to start scanning.
It shortens the interval between setting the document and feeding the document to the starting position.
R
Resolution
A measurement to indicate the quality (fineness) or an image. Resolution is displayed by the number of pixels within an
inch. Since image data is a collection of small dots (pixels), if the same image contains different amount of pixels, the one
with more pixels can express greater details. Therefore, the higher the resolution, the finer the image becomes.
S
SCSI
SCSI (Small Computer System Interface) is a standard for interfaces, used to connect devices such as hard disks and
scanners. Up to seven devices can be connected by this interface (daisy chain). The data transfer rate is 10 MB/sec. at
maximum for Fast SCSI, and 20 MB/sec. at maximum for Wide SCSI.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables

Troubleshooting

Operational
Settings
Appendix
Glossary
206