Dropout Color - Fujitsu 6240 - fi - Document Scanner Operator's Manual

Chapter 9 Operational Settings
Removing a Color from the Scanned Image

[Dropout color]

With "Dropout color", you can select either green, red, or blue
(primary colors) to remove the details of the selected color
from a scanned image.
For example, if a document with black characters and a green
background is scanned, only the black characters will appear
on the scanned image if [Green] is selected.
Dropout works the best with light (low intensity) colors, and
dark colors may not drop out.
Dropout color is only available in black & white or grayscale
mode.
1
Start up the Software Operation Panel.
Refer to "9.1 Starting Up the Software Operation Panel" (page
2
From the listing on the left, select [Device Setting 2]
[Dropout color].
153).
3
Select a color to drop out.
Red, Green, Blue : The selected color is dropped out.
None
The Software Operation Panel allows you to choose the
color from red, green, and blue only. To drop out a color of
your choice, configure the setting from the scanner driver.
For more details, refer to
Scanned Image (Dropout Color)" (page
With TWAIN driver, this setting can also be configured
from the scanner driver's setup dialog box. Note that
priority is given to the scanner driver setting.
With ISIS driver, the scanner driver setting is enabled at
all times.
: No color is dropped out.
"Removing a Color from the
82).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
173