Using The Ethernet Card In Print Server Mode - Epson C823642 - Enet Print Server Type B Multi Protocol 10/100BTX Administrator's Manual

If the bindery context path has not been set, or if you want
to switch the bindery context to print in a different bindery
context from that of a bindery client, use SET BINDERY
CONTEXT command to set the context in the
AUTOEXEC.NCF file.
See your Netware 4.1x manual for more information.
IPX routing protocol NLSP
It is possible to use the IPX routing protocol NLSP in
NetWare4.1x; however, the Ethernet card does not support
NLSP. RIP/SAP controls the communication.
You can select NLSP with RIP/SAP Compatibility or RIP/SAP
Only. If you arbitrarily remove the RIP or SAP binding when
NLSP with RIP/SAP Compatibility is specified, the Ethernet card
is not able to communicate with the file server and NDS.
(Reference: "Protocols" and "Bindings" in the menu items of the
Utility INETCFG.)
Time required to recognize the Ethernet card
It takes up to two minutes for the NetWare server to recognize
the Ethernet card after the printer is turned on. During this start-
up time, EPSON Net!2 and the status sheet do not show the
correct information.

Using the Ethernet card in Print Server mode

This section explains how to configure the Ethernet card in Print
Server mode using the Nwadmin tool of NetWare 4.1x.
If the client does not correspond to NDS, set up the printer, print
server, and queue in Bindery context.
1. Log in to the NDS tree (or to the server with Bindery context) with
admin or supervisor privileges.
2. Run the administrator tool (Nwadmin).
Using the Ethernet Card with NetWare 4-17