Fujitsu Eternus DX60 User Manual page 122

Chapter 6 Cable Connection
6.6 MiniSAS Cable Connection (For Drive Enclosures)
2
2-1
2-2
When two or more drive enclosures are installed, connect the drive enclosures
with the miniSAS cable.
Connect the SAS (OUT) port at expander 0 (EXP#0) of the drive enclosure 1, to the
SAS (IN) port at expander 0 (EXP#0) of the drive enclosure 2 with the miniSAS cable.
(1) Connect the plug to be connected to the SAS (OUT) port, to the SAS (OUT) port of
the expander 0 (EXP#0) for the drive enclosure 1.
Drive
enclosure 1
(2) Connect the connector to be connected to the SAS (IN) port, to the SAS (IN) port of
the expander 0 (EXP#0) for the drive enclosure 2.
Drive
enclosure 2
For dual controller model, connect the SAS (OUT) port at expander 1 (EXP#1) of the
drive enclosure 1, to the SAS (IN) port at expander 1 (EXP#1) of the drive enclosure 2
with the miniSAS cable.
Connect the miniSAS cable in the same way as
The following figure shows the miniSAS connection figure between drive enclosures.
Do not connect anything to the SAS (OUT) port on the end edge.
IMPORTANT
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Step
122
2-1.
P3AM-3042-08ENZ0