Chapter 5 Installation
5.2 Rack Installation
■ 2.5" type controller enclosure
8
•
Use the thumb screw to fasten the front right of the controller enclosure to the rack.
•
After attaching the supplied flange cover, use the thumb screw to fasten the front left of
the controller enclosure to the rack.
For details on how to attach the flange cover, refer to
Flange Cover" (page
78).
Thumb screw
For a 3.5" type controller enclosure, replace the front cover.
For details on how to attach the front cover, refer to
Cover" (page
75).
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
(Rear rack pillars)
"3.3 Attaching and Removing the Front
95
"3.4 Attaching and Removing the
End of procedure
P3AM-3042-08ENZ0