Fujitsu Eternus DX60 User Manual page 93

Chapter 5 Installation
5.2 Rack Installation
2
3
Adjust the rack rails (bracket L (for left side) and bracket R (for right side)) sizes
to fit the rack.
Reposition the M4 screws to adjust the length of the rack rails (brackets) to match the
distance between the front and rear rack pillars. Leave the M4 screws slightly unscrewed,
as the bracket must be attached to the rack before they can be completely tightened.
Bracket L (for left side)
"L" is stamped on the inner
side of the left rack rail.
[Left]
(Front rack pillars)
[Right]
Attach the rack rails (brackets) to the rack.
• When the holes in the rack pillars are square, use the screw
holders to attach.
• Make sure to attach the rack rails (brackets) and rack pillars so
that they fit exactly together without any space between them.
Bracket L
Screw holders
M5 screws
(Front rack pillars)
M5 screws
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
(Rear rack pillars)
Loosen the M4 screws,
and adjust the rack rails to
the depth of the rack.
Bracket R (for right side)
"R" is stamped on the inner
side of the right rack rail.
Screw holders
(Rear rack pillars)
Bracket R
Screw holders
93
M5 screws
M5 screws
Screw holders
P3AM-3042-08ENZ0