Chapter 8
The following optional products may be installed while the ETERNUS DX60/DX80/DX90 is run-
ning (hot-expansion procedures).
•
Disk
•
Drive Enclosure
This chapter explains how to install these optional products.
Be sure to read "ETERNUS DX60/DX80/DX90 Disk storage system Using Optional Products"
before performing any of these installation procedures.
Refer
8.1
Disk Installation
This section describes how to install optional disks in the ETERNUS DX60/DX80/DX90.
8.1.1
Disk Handling Instructions
■
About condensation
Installing Optional Products
"ETERNUS DX60/DX80/DX90 Disk storage system Using Optional
Products"
Do
CAUTION
•
When moving a disk from a cold place, such as an un-conditioned
store house in winter, to a warmer places such as an air-conditioned
room, the severe temperature change may result in condensation
forming.
To avoid this, allow the packed disks sufficient time in the warmer
place (one hour for each 15°C of temperature difference) to adapt to
the new temperature.
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
185
P3AM-3042-08ENZ0