Fujitsu Eternus DX60 User Manual page 73

Chapter 3 Standard Operations
3.1 Power ON Control
Procedure
1
2
3
Press the power switch ( ) of the controller enclosure.
Controller enclosure POWER LED turns on.
When drive enclosures are installed, the power turns on
automatically.
Power switch
After a few minutes, check that controller enclosure's READY LED is lit up.
Check that all enclosure's POWER LED and READY LED are lit up.
LED for
drive enclosure
LED for
controller enclosure
ETERNUS DX60/DX80/DX90 Disk storage system User Guide
Copyright 2011 FUJITSU LIMITED
Drive enclosure
Drive enclosure
Controller enclosure
Drive enclosure
Drive enclosure
Controller enclosure
73
End of procedure
P3AM-3042-08ENZ0