Configuring Voice Mail For Amis - Toshiba Strata CIX Programming Manual

Destination System Number
The Destination System Number consists of a country code (the digit "1" in North America), area
code, and seven-digit phone number. This number not only identifies the calling system, but can
also be used by the administrator to configure the local system to enable message replies.

Configuring Voice Mail for AMIS

There are two steps to configuring voice mail to act as an AMIS node:
1. Set the voice mail AMIS system parameters.
2. Create Gateway User Agents for each remote system with which voice mail communicates and
Proxy User Agents for each remote user that wishes to have a local address.
Step 1: Set AMIS Parameters
For AMIS to operate correctly, you must check the AMIS configuration parameter settings in the
voice mail system and modify their settings appropriately. See
for instructions on modifying the settings for the AMIS parameters shown in
Table 10-2 AMIS Parameters
Parameter
sys_amis_area_code
sys_amis_country_code
sys_amis_disk_full
sys_amis_enabled
sys_amis_failure_retry
sys_amis_loopback_enable
sys_amis_ltm
sys_amis_max_msg
Strata CIX Voice Mail Programming
Area code of the resident voice mail system. Single quotes are required.
Default: blank comment line
Country code of the resident voice mail system. Single quotes are required.
Default: comment line starting with 1 for North America.
Percentage of the hard drive that must be free in order for voice mail to
accept new AMIS messages. If free space is less than this figure, voice mail
tells the calling AMIS system that the hard drive is full.
Default: 5 (percent)
Whether voice mail processes incoming AMIS calls.
Possible values:
True: Voice mail processes incoming AMIS calls.
False: (default) AMIS calls told that this node is not accepting network
calls.
Number of retries after failure.
Possible values: 0~9 (default = 3)
Enables the AMIS loopback test feature.
Possible values:
True: (default) enables feature
False: disables feature
User Agent number to use for the AMIS Loopback mailbox. User Agent other
AMIS nodes can use for testing the network. Any AMIS message to this User
Agent is sent back to the sender, if accessible from this voice mail system.
Possible values: valid User Agent number.
Default: 989
Maximum number of messages the AMIS system can receive.
Default: 1000
01/07
Advanced Integrations and Applications
"Modify Parameters" on page 3-30
Table .
Description
AMIS Networking
10-9