Testing Amis; Amis Operation - Toshiba Strata CIX Programming Manual

The Destination System Number is the telephone number the remote node uses as
Note
identification. The format (including # signs): 1#area code#telephone number#.
Example1#714#5551212#
10.In the Destination Dial Number field, type the telephone number including the area code and
any special digits (e.g., 9) for dialing out. Example: 917145833777
11. (For AMIS Proxy User Agent only) In the Destination Mailbox field, accept the default or type
in a different User Agent. Default is User Agent 998.
12. In the Notification Port Group field, accept the default or type in a different port group. Default
is Q1.
Note See Chapter 3 – Voice Mail Configuration
Groups.
13. Using the spin button, set the Notify After(min), Continue Every(min) and Notify Max Time
fields.
14. Click Submit. The data is saved.
15. Repeat Substeps 6~14

Testing AMIS

One method of testing AMIS involves using the AMIS Loopback User Agent (default 989). Once
enabled using the sys_amis_ltm parameter, this User Agent can be used by other AMIS nodes for
testing the network. Voice mail sends any AMIS message to this User Agent back to the sender,
assuming the sending system is accessible from the voice mail system.
A line monitor can be used to analyze AMIS transmissions. However, to validate AMIS completely,
an in-depth knowledge of AMIS Analog Protocol is required.

AMIS Operation

AMIS messages can only be sent from mailboxes.
Note
AMIS networking operation consists of the following steps:
Send Message Over AMIS Network
1. The user logs into his/her mailbox.
2. From the Main Menu, the user presses
3. The user specifies the destination address as one of the following:
•
node + mailbox number – if the address is a unique combination of the Gateway mailbox
and destination mailbox.
*
•
node + + mailbox number – if the address is not a unique combination of the Gateway
mailbox and destination mailbox.
•
Proxy User Agent number – if addressing the message to a Proxy User Agent.
where:
NODE = up to eight digits
remote address = up to 16 digits
4. The user records the message and presses
5. The user presses
Strata CIX Voice Mail Programming
above for any other agents you created.
2
for the Send Messages menu.
#
#
again to send the message to the specified node.
01/07
Advanced Integrations and Applications
for instructions on creating Notification Port
to stop recording.
AMIS Networking
10-11