Toshiba Strata CIX Programming Manual page 208

Token Programming
Defined Tokens
Table 11-3 Defined Tokens (continued)
Token
length
termination List of characters that defines when Stratagy ES should stop reading from the serial
timeout
S( )
(continued)
Example S(1,"GET INFO",%S1,"\N",80,40)
where:
1
"GET INFO" String sent out of port by Stratagy ES.
%S1
\N
80
40
Transmit fax–performs fax transmissions to either a specified telephone number or to a connected
call. For a two-call fax back, use the two-option syntax. For a one-call fax on demand, use the three-
option syntax.
Note This token is not currently supported.
If Stratagy ES has a free fax port available, transmission begins shortly on that port. Otherwise, the
request will be queued for transmission along with any other such requests. Normally you will install
your fax software so that if a transmission fails (for instance, if the remote fax is busy), then the
request will be retried automatically at a later time, up to a maximum number of retries.
Syntax
T( )
where:
file
string
""
tokens
11-16
Maximum number of characters to expect as input on the serial port. If the maximum
number of characters is received, processing continues immediately with whatever
characters that were received placed in the %Sn variable. If this option is omitted, it
defaults to the maximum length of %Sn (128 characters).
port for storing in the specified %Sn variable. If omitted, defaults to "\N\R" as specified
under "S". The terminating character, if any, is not part of %Sn.
Maximum time (tenths of seconds) Stratagy ES waits for input on the serial port when
reading into the %Sn variable. When the timeout expires, Stratagy ES continues
processing with the next token. Whatever characters, if any, received up to that point are
placed in the %Sn variable. If this option is omitted, the default is the value of the
Stratagy ES System Configuration parameter sys_tmo_serial
Configuration).
Logical serial port.
Store response in %S1 variable.
Newline (Line feed)
Maximum number of characters expected as input from serial port.
Four-second time out waiting for input from serial port.
T(file,string)
T(file,"",tokens)
File name of the fax you want to transmit. Valid DOS file name.
DTMF digits representing the telephone number to dial to connect to the fax device that
accepts the transmission. It can contain %S storage variables. If it is the empty string,
i.e., "", then Stratagy ES waits until a call rings into the fax port.
Empty string. Stratagy ES implements the defined tokens.
Stratagy ES implements the defined tokens to transfer the call to the Stratagy ES so fax
transmission can begin. Typically it would be P(G1), which plays greeting 1: "Start your
fax machine at the tone."
Description
Strata CIX Voice Mail Programming
(Chapter 3 — Voice Mail
01/07