Profiles > Mesh > Radio > Mesh Ht Ssid - Dell PowerConnect W-Airwave Configuration Manual

Table 37 Aruba Configuration > Profiles > Mesh > Radio Profile Settings (Continued)
Field
Transmit Power
(0-30 dBm)
Retry Limit (0-15)
RTS Threshold
(256-2346 bytes)
802.11a Transmit
Rates
802.11g Transmit
Rates
Mesh Private VLAN
(0-4094)
BC/MC Rate
Optimization
3. Click
Profiles > Mesh > Radio > Mesh HT SSID
The mesh high-throughput SSID profile enables or disables high-throughput (802.11n) features for the SSID
specified in the profile. This parameter is enabled by default. The mesh high-throughput profile can have a
maximum of 32 characters.
Perform these steps to configure a
1. Click
the current profiles of this type.
2. Click the
profile to edit that profile. The
Table 38 Aruba Configuration > Mesh > Radio > Mesh HT SSID Profile Settings
Field
General Settings
Folder
AirWave Wireless Management Suite | Configuration Guide
Default
30
4
2333
All selected
All selected
0
Yes
Add Save
or . The added or edited
Profiles > Mesh > Radio > Mesh HT SSID
Add
button to create a new
Default
Top
Description
Define the transmission power supporting mesh profiles, as described for
the portal channel settings immediately above. This setting supports a
range from 0 to 30 dBm.
Indicate the number of times a mesh node can re-send a packet. This
setting supports a range from 0 to 15.
Define the packet size sent by mesh nodes. Mesh nodes transmitting
frames larger than this threshold must issue request to send (RTS) and
wait for other mesh nodes to respond with clear to send (CTS) to begin
transmission. This helps prevent mid-air collisions. The supported range is
from 256 to 2346 bytes.
Indicate the transmit rates for the 802.11a radio. The AP attempts to use
the highest transmission rate to establish a mesh link. If a rate is
unavailable, the AP goes through the list and uses the next highest rate.
Indicate the transmit rates for the 802.11g radio. The AP attempts to use
the highest transmission rate to establish a mesh link. If a rate is
unavailable, the AP goes through the list and uses the next highest rate.
Enter a VLAN ID for control traffic between an remote mesh portal and
mesh nodes. This VLAN ID must not be used for user traffic.
Range: 0-4094. Default: 0 (disabled).
Enable or disable scanning of all active stations currently associated to a
mesh point to select the lowest transmission rate based on the slowest
connected mesh child.
When enabled, this setting dynamically adjusts the multicast rate to that of
the slowest connected mesh child. Multicast frames are not sent if there
are no mesh children.
NOTE: AirWave recommends using the default value.
Radio
profile appears on the
Mesh HT SSID
profile.
Aruba Navigation
in the
Mesh HT SSID
profile, or click the
Details
page appears. Complete the settings as described in
Description
Use this field to set and display the folder with which the profile is
associated. The drop-down menu displays all folders available for
association with the profile. Folders provide a way to organize the
visibility of device parameters that is separate from the configuration
groups of devices. Using folders, you can view basic statistics about
device, and define which users have visibility to which device
parameters.
Profiles > Mesh > Radio
page.
pane. The details page summarizes
pencil
icon next to an existing
Table
Aruba Configuration Reference |
18:
109