Dell PowerConnect W-Airwave Configuration Manual page 113

You enable this feature in the VoIP CAC profile. You also need to enable call admission control, which is
disabled by default, in this profile. Perform these steps to create or edit VoIP Call Admission Control
profiles.
1. Click
2. Click the
an existing profile. The
Table 41 Aruba Configuration > Profiles > QoS > VoIP Call Admission Control Profile Settings
Field
General Settings
Folder
Name
Other Settings
VoIP Call Admission
Control
VoIP Active Load
Balancing
VoIP Vocera Call
Capacity (0-255)
VoIP NOE Call
Capacity (0-255)
VoIP SIP Call
Capacity (0-255)
VoIP SVP Call
Capacity (0-255)
VoIP SCCP Call
Capacity (0-255)
VoIP H.323 Call
Capacity (0-255)
VoIP T-Spec Call
Capacity (0-255)
VoIP Call Handoff
Reservation (0-100%)
AirWave Wireless Management Suite | Configuration Guide
Profiles > QoS >
VoIP Call Admission Control in the
Add
button to create a new
Details
Default
Top
Blank
No
No
20
10
10
10
10
10
10
20
VoIP Call Admission Control
page appears. Complete the settings as described in
Description
Use this field to set and display the folder with which the profile is
associated. The drop-down menu displays all folders available for
association with the profile.
Folders provide a way to organize the visibility of device parameters that
is separate from the configuration groups of devices. Using folders, you
can view basic statistics about device, and define which users have
visibility to which device parameters.
Enter the name of the threshold profile.
Enable or disable VoIP Call Admission Control in this profile.
Enable or disable load balancing in this profile.
Specify the bandwidth allocation to Vocera voice calls when Admission
Control is enabled.
Specify the bandwidth allocation to New Office Environment (NOE) voice
calls when Admission Control is enabled.
Specify the bandwidth allocation to Session Initiated Protocol (SIP) voice
calls when Admission Control is enabled.
Specify the bandwidth allocation to SpectraLink Voice Priority (SVP) voice
calls when Admission Control is enabled.
Specify the bandwidth allocation to Cisco Skinny Client Control Protocol
(SCCP) voice calls when Admission Control is enabled.
Specify the bandwidth allocation to H323 protocol traffic when Admission
Control is enabled.
A WMM client can send a Traffic Specification (TSPEC) signaling request
to the AP before sending traffic of a specific AC type, such as voice. You
can configure the controller so that the TSPEC signaling request from a
client is ignored if the underlying voice call is not active; this feature is
disabled by default. If you enable this feature, you can also configure the
number of seconds that a client must wait to start the call after sending
the TSPEC request (the default is one second).
You enable TSPEC signaling enforcement in the VoIP Call Admission
Control profile. This field specifies the bandwidth allocation to T-Spec
voice calls when Admission Control is enabled.
Specify the total bandwidth to be reserved for call handoff. This field is a
percentage of entire bandwidth.
Aruba Navigation
pane.
,
profile or click the
Table
Aruba Configuration Reference |
pencil
icon to edit
30:
113