Dell PowerConnect W-Airwave Configuration Manual page 86

Table 20 Aruba Configuration > Profiles > AP > System Profile Settings (Continued)
Field
Remote-AP DHCP
Server VLAN
(1-4094)
Remote-AP DHCP
Server ID
Remote-AP DHCP
Default Router
Remote-AP DHCP
DNS Server
Remote-AP DHCP
Pool Start
Remote-AP DHCP
Pool End
Remote-AP DHCP
Pool Netmask
Remote-AP DHCP
Lease Time
(0-30 days)
Heartbeat DSCP
(0-63)
Session ACL
Corporate DNS
Domain
Image URL
Maintenance Mode
3. Click
86 | Aruba Configuration Reference
Default
N/A
N/A
N/A
N/A
N/A
N/A
255.255.255.0
0
0
none
N/A
N/A
No
Add Save
or . The added or edited
Description
Specify the VLAN to be associated with the remote-AP DHCP server. This
field requires a remote access points license, when used.
Specify the IP address of the remote-AP DHCP server.
Specify the IP address of the remote-AP DHCP default router. This field
requires a remote AP license. This field requires a remote access points
license, when used.
Enter the IP address or addresses of one or more remote-AP DHCP DNS
servers.
Specify the DHCP IP address pool. This configures the pool of IP
addresses from which the remote AP uses to assign IP addresses.
At the Remote-AP-DHCP Pool Start and End fields, enter the first and last
IP addresses of the pool. These fields require a remote access point
license, when used.
Enter the subnet mask. This field requires a remote access points license,
when used.
Specify the amount of time that the IP address of the DHCP server is valid.
The supported range is from 0 to 30 days. A value of 0 disables this
function. This field requires a remote access points license, when used.
This setting defines DSCP for low-speed networks. The supported range is
from 0 to 63. To enable this function, enter a value greater than 0.
Select an access control list for user sessions. Options are as follows:
none
stateful-dot11x
stateful kerbos
valid user
Enter the domain name service (DNS) domain or domains, one per line.
If an AP developers license is active, enter the image URL in a range from
1 to 1024. This setting requires an AP Developer license, when used.
You can configure APs to suppress traps and syslog messages related to
those APs. Known as AP maintenance mode, this setting in the AP system
profile is particularly useful when deploying, maintaining, or upgrading the
network. If enabled, APs stop flooding unnecessary traps and syslog
messages to network management systems or network operations centers
during a deployment or scheduled maintenance. The controller still
generates debug syslog messages if debug logging is enabled. After
completing the network maintenance, disable AP maintenance mode to
ensure all traps and syslog messages are sent. AP maintenance mode is
disabled by default.
System
profile appears on the
AirWave Wireless Management Suite | Configuration Guide
System
profiles list page.