NEC Express5800 320La User Manual page 180

Table 5-3. POST Error Codes and Messages (continued)
Error Code and Message
0B22 CPUs are installed out of order CPU is faulty.
0B24 DIMMs are installed out of
order
0B26 Invalid MAC Address detected FRB2 Timeout error
0B28 Unsupported Processor
detected on Processor 1
0B29 Unsupported Processor
detected on Processor 2
0B30
CPU FAN #1 Alarm occurred
0B31 CPU FAN #2 Alarm occurred
0B32
CPU FAN #3 Alarm occurred
0B47 Missing date and time
synchronization
0B70
The error occurred during
temperature sensor reading
0B71
System temperature out of
Range
0B80
BMC Memory Test Failed
0B81
BMC Firmware Code Area
CRC check failed
0B82
BMC core Hardware failure
0B83 BMC IBF or OBF check failed
0B84 BMC issued Reset Command,
but failed System Reset
0B90 BMC Platform Information
Area corrupted
0B91
BMC update firmware
corrupted
0B92
Internal Use Area of BMC FRU
corrupted
5-26 Problem Solving
Description
DIMM is faulty.
occurred at SetMAC, and
rewriting of MAC address
failed.
The processor (CPU) not
supported by this server is
installed in Processor 1.
The processor (CPU) not
supported by this server is
installed in Processor 2.
Dust obstructing the fan.
Fan is faulty.
CPU module board is
faulty.
Dust obstructing the fan.
Fan is faulty.
PCI module board is faulty.
The date and time are
incorrect due to a
communication error
between BMCs.
SMBus device is faulty.
SMBus is faulty.
Fan is faulty.
CPU/PCI module board is
faulty.
BMC is faulty.
BMC Reset command is
disabled and failed to reset
the system.
BMC is faulty.
SROM is faulty.
BMC is faulty.
Action
Replace the CPU.
Replace the DIMM.
Replace the front panel board.
Install the CPU appropriate to
the server.
Install the CPU appropriate to
the server.
Replace the fan.
Replace the CPU module
board.
Connect fan cable properly.
Replace the fan.
Replace the PCI module
board.
Connect fan cable properly.
Restart the system.
Re-set the date and time in
SETUP.
If the error persists, replace the
PCI module board.
Replace the CPU/PCI module
or front panel board.
Clean the fan.
Replace the fan.
Replace the PCI module
board.
Replace the PCI module
board.
Replace the PCI module
board.
Replace the PCI module
board.