Silvercrest SL 80/2 100CI Operation And Safety Notes page 64

Press the arrow keys left (10) or right (11) to change the end time by one
minute earlier (arrow key left (10)) or later (arrow key right (11)).
Always enter the start and end time with some buffer in order to include
possible shifts or extra lengths. You can later on edit out superfluous
recording time by using the editing function for recordings.
Channel
Set the desired channel on which the transmission to be recorded is going to
be broad/telecast.
Press the arrow keys left (10) or right (11) to change the channel by one
channel step (1 MHz) downwards (arrow key left (10)) or upwards (arrow
key right (11)).
Timer mode
Select the repeat rate in the Timer mode. You can select from the modes
"single", "Daily", "Weekends", "Weekdays" or "Weekly".
The "Weekend" mode includes the days Saturday and Sunday.
If the setting is "Weekly", the recording is repeated "every week at the
set time (and day)".
In the "Weekdays" mode, the recordings are repeated Mondays till
Fridays.
Press the arrow keys left (10) or right (11) to change the setting.
or
Press the "OK" key (14). A selection window appears.
Select the desired setting by using the arrow keys up (12) or down (13).
Confirm your selection by pressing the "OK" key (14).
Power mode after rec.
Modify the status of the receiver after the recording is over. If the set is to be
switched in the Stand-by mode, select "Stand-by". Select "Switch on", if the
set is supposed to go into the operating mode after the recording.
- 61 -