NEC Express5800 User Manual page 135

3.
Apply the Service Pack.
When you use Microsoft Service Pack 1 CD-ROM:
Insert Service Pack 1 CD-ROM into the DVD-ROM drive pressing SHIFT key.
Then double-click WINDOWSSERVER2003-KB889101-SP1-X86-ENU.EXE.
When you use Service Pack 1 that downloaded from Web-site:
Double-click <voluntary directory (ex. c:\temp)>:\WINDOWSSERVER2003-
KB889101-SP1-X86-ENU.EXE.
Continue performing tasks according to the messages.
The installation of Service Pack 1 will be started.
When Service Pack 1 has been installed, the [Windows Server 2003 Service Pack 1 Setup
Wizard] screen will be displayed.
Click on [Finish] to restart the system.
4.
Insert the NEC EXPRESSBUILDER CD-ROM into the DVD-ROM drive.
Master Control Menu is automatically appeared on the screen.
5.
Click on [Setup] with left mouse button and click on [Update the system] section.
6.
Continue your work for system update as the following message.
7.
Click on [OK] to restart the system.
8.
Remove the NEC EXPRESSBUILDER CD-ROM from the DVD-ROM drive
immediately after clicking on [OK].
IMPORTANT: If you change the configuration of the system (by
adding or removing hardware or Operating system software
components) or repair the system, you must run the system update
again.
<Windows Server 2003 x64 Editions/Windows 2000>
Update the system in the situation below:
Modified system configuration.
Recovered the system using recovery process.
Log on to the system with the account that has administrative authority (e.g. Supervisor) and insert
the NEC EXPRESSBUILDER CD-ROM into the DVD-ROM drive of the server.
[Setup] in [Master Control Menu] screen appears, so left-click the item. Click [Update the System]
from the menu and the setup will start. After that, follow the message to continue the setup process.
Installing the Operating System with Express Setup 5-27