Table of Contents
Advertisement
Item number
Item
612
VITC POSITION-2
select (NTSC)
613
TC OUTPUT
SIGNAL IN
REGENE MODE
614
PHASE
CORRECTION
616
VITC POSITION-1
select (PAL)
617
VITC POSITION-2
select (PAL)
Setting
Function
12 line
When 29.97PsF/59.94i mode is selected on the VTR, this
. . .
setting specifies the lines in which the VITC signal is
inserted.
[18 line]
. . .
It can be inserted in any lines from 12 to 20.
20 line
Note
Items 611 and 612 allow VITC to be inserted in two lines.
[off tape]
Specifies the signal output to the TIME CODE OUT
regene
connector when the internal time code generator is in a
through
mode for regenerating the playback time code (i.e. during
auto edit mode or when item 607 is set to int-LTC or int-
VITC and item 606 is set to "regene".)
off tape: The playback time code signal is output to the
regene: The playback time code signal is output to the
through: The time code signal input to the TIME CODE IN
[off]
Specifies whether the phase correction control of the LTC
on
signal generated by the time code generator is applied or
not.
off: The phase correction control is not applied.
on: The phase correction control is applied.
9,322 line
When 25PsF/50i mode is selected on the VTR, this setting
. . .
specifies the lines in which the VITC signal is inserted.
[19,332 line]
It can be inserted in any lines from 9,322 to 22,335.
. . .
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
9,322 line
When 25PsF/50i mode is selected on the VTR, this setting
. . .
specifies the lines in which the VITC signal is inserted.
[21,334 line]
It can be inserted in any lines from 9,322 to 22,335.
. . .
22,335 line
Note
Items 616 and 617 allow VITC to be inserted in two lines.
TIME CODE OUT connector without regeneration.
TIME CODE OUT connector after regeneration only
when the VTR is in playback mode.
connector is output as it is.
(Continued)
A-29
Appendix
Advertisement
Table of Contents
