Dell PowerEdge M820 Owner's Manual page 103

Error Code Message Information
HWC5031
Message
Details
Action
HWC5032
Message
Details
Action
HWC5034
Message
Details
Action
HWC5036
Message
Details
Action
HWC6000
Message
Details
Action
HWC6002
Message
Details
Action
HWC6003
Message
HWC6004
Message
Details
IO module <number> is offline.
The CMC has powered off the IOM.
If the issue persists, see
A fabric mismatch detected on IO module <number>.
The fabric type for IOM's on the same chassis fabric must
match.
Check chassis fabric type in CMC GUI and compare to the
type of both IOM's.
A link tuning failure detected on IO module <number>.
Link tuning table not supported for this IO modular.
Update the CMC firmware. If the issue persists, see
Help.
A failure is detected on IO module <number>.
The IOM module performance may be impacted.
If the issue persists, see
The <name> controller is offline.
Information and status from the controller is unavailable.
Remove and reapply input power. If the issue persists, see
Getting Help.
The <name> controller is stuck in boot mode.
Information and status from the controller is unavailable.
Remove and reapply input power. If the issue persists, see
Getting Help.
The <name> controller is booting.
Cannot communicate with <name> controller.
Information and status from the controller is unavailable.
Getting Help.
Getting Help.
Getting
103