Hardwire Interior Speaker (60-528); Connecting Exterior/Interior Piezo Sirens; Output 1; Piezo Dynamic Exterior Siren (13-950) - GE Concord 4 Series Installation Instructions Manual

Note
For 24-hour backup, exter-
nal power drain is limited to
90 mA (during normal
standy condition), using a
4.5 Ah battery, or 190 mA
continuous using a 7.0 Ah
battery.
Concord 4 Series Systems

Hardwire Interior Speaker (60-528)

Connect interior speakers to the panel using 18-gauge wire as shown in Figure 10.
!
Connect only the large speaker to the panel terminals 7 and 8 as shown. The smaller
speaker cannot handle to output of terminals 7 and 8. To avoid damaging the speaker,
the smaller speaker should not be connected to terminals 7 and 8.
Caution
Panel
7
Terminals
Speaker
Figure 10. Connecting Hardwire Interior Speakers

Connecting Exterior/Interior Piezo Sirens

Output 1

Onboard output 1 (OUT 1—terminal 9) is a 9 to 14 VDC switched, programmable output that
can handle a maximum of 1,000 mA current. The default setting (01614) activates the output 30
seconds after a police or fire alarm condition occurs. This allows you to connect a piezo siren
without changing the output configuration number in programming. This output is typically used
for exterior siren applications. (For more information on output configuration numbers, see
"Onboard Options Menu".)

Piezo Dynamic Exterior Siren (13-950)

Note
This siren is not UL approved for use as an outdoor sounding device.
Connect the siren to panel as shown in Figure 11.
WWW.DIYALARMFORUM.COM
Not Used
8
O U T 1
9
Red
Figure 11. Connecting Exterior Sirens
Not Used
Panel
Not Used
7 8
Terminals
Speaker
G N D
Panel
1 3
Terminals
Black
14