Testing Outputs And Sirens - GE Concord 4 Series Installation Instructions Manual

73
Code
009
111
115
118
119
222
333
555
888
999
Table 10 describes pager sensor/zone number and user number report codes.
Table 10: Pager Sensor/Zone Code and Numbers
Code
000
001–096
600–829
830-837
838-845
846
847
848
850
851
852

Testing Outputs and Sirens

All outputs (onboard and SnapCard) should be tested to verify configuration programming.
!
Be sure to contact the central monitoring station before activating outputs that trigger
from an alarm condition.
Caution
To test outputs:
1. Contact the central monitoring station to inform them you are testing the system.
2. Verify that all wiring at the panel and output devices is correct.
3. Activate the appropriate device to trigger each output as programmed.
4. Verify that each output responds according to the programmed configuration number. For
outputs that trigger sirens, verify that the correct alarm sounds are produced from these
sirens. Table 11 describes the system alarm sounds you should hear for each alarm event.
5. Contact the central monitoring station when you are finished testing.
Alarm Type
Fire
Police/Intrusion Continuous tone
Auxiliary
WWW.DIYALARMFORUM.COM
Table 9: Pager System Event Codes
System Event
Zone Restoral
System Disarmed
Sensor Test Exit
Trouble condition cleared
Alarm Canceled
System Armed to STAY
System Armed to AWAY
Phone/Sensor Test
System Trouble Condition
System in Alarm
Sensor/Zone or User Number
System event not caused by a zone or user
Sensor/Zone Numbers 1–96
Regular User Codes 0–229 used
Partition Master Code used
Partition Duress Code used
System Master Code used
Installer Code used
Dealer Code used
Quick Arm used
Keyswitch Sensor used
System Armed Itself (during service or power-up)
Table 11: System Alarm Sounds
Alarm Sound
Repeating series of three beeps
Rapid beeps
Concord 4 Series Systems