Table of Contents
Advertisement
Note
The panel cannot be used
on a digital or PBX phone
line. These systems are
designed for digital type
devices only, operating any-
where from 5 volts DC and
up. The panel uses an ana-
log modem and does not
have a digital converter,
adapter, or interface to oper-
ate through such systems.
Note
Connecting the panel to an
analog line off the phone
switch places the panel
ahead of the phone system,
preventing panel access
from phones on the pre-
mises. However, the panel
can still be accessed from
off-site phones.
21
SuperBus 2000 Automation Module (60-783-02)
Connect the SuperBus 2000 Automation Module to the panel as shown in Figure 24.
G N D
Panel
3
Terminals
SuperBus 2000 Wireless Gateway-Ready Kit (600-1010)
Connect the SuperBus 2000 Wireless Gateway Module to the SuperBus 2000 terminals as shown
in Figure 25.
!
Since the SuperBus Wireless Gateway-Ready Kit draws more than 1 amp, it must be
powered by the SuperBus 2000 2 Amp Power Supply and not the panel.
Caution
SuperBus 2000
2 Amp Power
Supply Terminals
Figure 25. Connecting the Wireless Gateway Module to the Panel
Installing an RJ-31X Phone Jack (13-081)
Use the following guidelines when installing an RJ-31X phone jack for system control by phone
and central station monitoring.
•
Locate the RJ-31X jack (CA-38A in Canada) no further than five feet from the panel.
•
The panel must be connected to a standard analog (loop-start) phone line, that provides 48
volts DC (on-hook or idle).
•
For full line seizure, install an RJ-31X phone jack on the premises phone line so the panel is
ahead of all phones and other devices on the line. This allows the panel to take control of the
phone line when an alarm occurs, even if the phone is in use or off-hook.
•
If an analog line is not available, contact a telecommunications specialist and request an ana-
log line off the phone switch (PBX mainframe) or a 1FB (standard business line).
To connect a phone line to the panel using an RJ-31X/CA-38A jack:
1.
Run a 4-conductor cable from the TELCO protector block to the jack location (see A in Fig-
ure 26).
2.
Connect one end of the cable to the jack (see B in Figure 26).
3.
At the TELCO protector block, remove the premises phone lines from the block and splice
them to the black and white (or yellow) wires of the 4-conductor cable (see C in Figure 26).
WWW.DIYALARMFORUM.COM
Automation Module Circuit Board
1 2 3 4 5 6
+ 1 2 V
A
B U S
B
4
5
6
Figure 24. Connecting the SuperBus to the Panel
+ 1 2 V
A
B
G N D
2 4 V A C
2 4 V A C
+ 1 2 V
B U S A
B U S B
DB-9 Serial Cable
Automation
Device
Z 1
Z C O M
+ 1 2 V
G N D
G N D
Z O N E
G N D
O U T
Concord 4 Series Systems
Hide quick links:
Advertisement
Table of Contents
