Sharp IV-C35M User Manual page 219

Multiple Positional Measurement
How to set the register conditions
How to enter the REG-COND setting screen
There are three methods for getting to the REG-COND setting screen.
1) On the "MEAS CND" setting screen, move the
cursor to "
SET key. The cursor will move into the table.
Move the cursor to the "S" or "E" column and
press the SET key.
Note: If you press the SET key in the "X"
column, the setting will be invalid.
About "S"
About "E"
2) On the "MEAS CND" setting screen, press the
TRG/BRT key to move the cursor to the upper
function menu. Select the "COND" item and
then select the "REG-COND(S)" or "REG-
COND(E)" item and press the SET key.
About "REG-COND(S)"
See pages 15-5 to 7.
About "REG-COND(E) "
See pages 15-7 to 9.
3) On the menu tree, move the cursor to the
"MEAS CND" item, and press the right arrow
key. The sub menu which contains the "REG-
COND(S)" and "REG-COND(E)" items will
appear. Move the cursor to either of these
items and press the SET key.
About "REG-COND(S)"
See pages 15-5 to 7.
About "REG-COND(E)"
See pages 15-7 to 9.
DTECT OBJECT" and press the
See pages 15-5 to 7.
See pages 15-7 to 9.
MEAS CND SCREEN COND SAVE
1DTECT PRECISION
STANDARD
2
0(0~3)
3
GRAY-SRC
4DETECT ORDER
SCAN-ORDER
5
SET=COND FOR EACH REG ESC=BACK SEL=CHNG IMG TRG=FUNC
SELECT OBJECT TYPE COND
OBJECT TYPE COND
TYPE00
TYPE RUN COND
IMAGE-ADJ
MEA-CND(CAMERA1)
MEAS0
POSI-CORRECT
MEAS01(MULTI-POSI)
IMG PRE-PROC
MEAS CND
EVALUATION COND
DISTANCE&ANGLE COND
NUM-CALC
OUT-COND
MEAS(NEW)
MEA-CND(CAMERA2)
FINAL NUM. CALC
FINAL OUTPUT COND
OBJ-TYPE I/O
OBJ TYPE SYS.
SET=TO NEXT SUB-MENU ESC=BACK SEL=CHNG IMG TRG=POPUP
15-4
RED F C1 DRK
IMG PRE-PROC
REG-COND(S)
REG-COND(E)
EVALUATION
DST&ANGL
NUM-CALC
OUT
COLOR F C1 DRK
1REGISTER NO.
REG-COND(S)
REG-COND(E)