Sharp IV-C35M User Manual page 35

2 (From the preceding page)
No
Yes
Yes
Yes
Yes
No
Message display
Yes
Error display
1 (From the preceding page)
Positional correction
Yes
Setting the coordinate correction
values (X, Y, q)
Executing measurement 1
Was an error detected?
No
Executing measurement 2
Was an error detected?
No
Executing measurement 3
Was an error detected?
No
Executing measurement 4
Was an error detected?
No
No
Message display
Displaying the measurement results
(values, decisions etc.)
No
Positional correction yes
Display pattern after correction
[Measurement programs that can be
selected]
- Positional deviation measurement
- Degree of match inspection
- Lead inspection
- BGA/CSP inspection
(*2)
- Area measurement by binary
- Counting by binary conversion
- Object identification by binary
- Color evaluation
- Color unevenness inspection
- Color positional measurement
- Point measurement
- Multiple positional measurements
- Multiple degree of match inspection
- Fault inspection
The window coordinates are
corrected within the range set for
each type of measurement,
based on the correction value
determined in the steps marked with
*2.
PC calculation
Yes
Pattern display
Yes
Yes
Display pattern when setting
To the next page
1-27
Setting and Operating Outline
conversion
conversion
No
1