Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual page 109

5. PARAMETERS
Class No. Symbol
73 SC5 Internal speed command 5
Used to set speed 5 of internal speed commands.
74 SC6 Internal speed command 6
Used to set speed 6 of internal speed commands.
75 SC7 Internal speed command 7
Used to set speed 7 of internal speed commands.
76 TL2 Internal torque limit 2
Set this parameter to limit servo motor torque on the assumption
that the maximum torque is 100[%].
When 0 is set, torque is not produced.
When torque is output in analog monitor output, this set value is the
maximum output voltage ( 8V).
77 For manufacturer setting
Don't change this value by any means.
78
79
80
81
82
83
84
Name and function
5 - 24
Initial Setting Control
Unit
value range mode
r/min 0 to in-
300
stanta-
neous
permi-
ssible
speed
r/min 0 to in-
500
stanta-
neous
permi-
ssible
speed
r/min 0 to in-
800
stanta-
neous
permi-
ssible
speed
100 % 0
to
100
00
10000
10
10
100
100
100
0000
S
S
S
P S