Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual page 289

15. MR-E- AG SERVO AMPLIFIER COMPATIBLE WITH ANALOG INPUT
Class No. Symbol
44 *DI3 Input signal selection 3 (CN1-3)
Allows any input signal to be assigned to CN1-pin 3.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 3.
If forward rotation stroke end (LSP) or reverse rotation stroke end
(LSN) is assigned to pin 3 of CN1 with parameter No. 48, this
parameter cannot be used.
Input signal selection 4 (CN1-5)
45 *DI4
Allows any input signal to be assigned to CN1-pin 5.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 5.
If forward stroke end (LSP) or reverse rotation stroke end (LSN) is
assigned to pin 5 of CN1 with parameter No. 48, this parameter
cannot be used.
Input signal selection 5 (CN1-6)
46 *DI5
Allows any input signal to be assigned to CN1-pin 6.
The assignable signals and setting method are the same as in input
signal selection 2 (parameter No. 43).
0
This parameter is unavailable when parameter No. 42 is set to
assign the control change (LOP) to CN1-pin 6.
If reverse rotation stroke end (LSN) is assigned to pin 6 of CN1 with
parameter No. 48, this parameter cannot be used.
Name and function
2
Speed
Input signals of
control mode
CN1-pin 3
Torque
selected.
control mode
5
Speed
Input signals of
control mode
CN1-pin 5
Torque
selected.
control mode
0
Speed
Input signals of
control mode
CN1-pin 6
Torque
selected.
control mode
15 - 44
Initial Setting Control
Unit
value range mode
0882
Refer to
Name
and
function
column.
0995
Refer to
Name
and
function
column.
0000
Refer to
Name
and
function
column.
S T
S T
S T