Startup; Selection Of Control Mode; Position Control Mode - Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual

4. OPERATION

4.2 Startup

WARNING
CAUTION
Connect the servo motor with a machine after confirming that the servo motor operates properly alone.

4.2.1 Selection of control mode

Use parameter No. 0 to choose the control mode used. After setting, this parameter is made valid by
switching power off, then on.

4.2.2 Position control mode

(1) Power on
1) Switch off the servo-on (SON) signal.
2) When power is switched on, the display shows "C (Cumulative feedback pulses)", and in two second
later, shows data.
(2) Test operation 1
Using jog operation in the test operation mode, make sure that the servo motor operates. (Refer to
Section 6.8.2.)
(3) Parameter setting
Set the parameters according to the structure and specifications of the machine. Refer to Chapter 5 for
the parameter definitions and to Sections 6.5 for the setting method.
Parameter No.
Control mode, regenerative brake
0
option selection
1 Function selection 1
2 Auto tuning
3 Electronic gear numerator (CMX)
4 Electronic gear denominator (CDV)
Turn the power off after setting parameters No. 0 and 1. Then switch power on again to make
the set parameter values valid.
Do not operate the switches with wet hands. You may get an electric shock.
Before starting operation, check the parameters. Some machines may perform
unexpected operation.
During power-on for some after power-off, do not touch or close a parts (cable etc.)
to the servo amplifier heat sink, regenerative brake resistor, the servo motor, etc.
Their temperatures may be high and you may get burnt or a parts may damaged.
Name Setting
3 0
Position control mode
MR-RB12 regenerative brake option is used.
0 0 2
Input filter 3.555ms (initial value)
Electromagnetic brake interlock signal is not used.
Used in incremental positioning system.
1 5
Middle response (initial value) is selected.
Auto tuning mode 1 is selected.
1 Electronic gear numerator
1 Electronic gear denominator
4 - 2
Description