Mitsubishi Electric GENERAL PURPOSE AC SERVO MR-E- A/AG Instruction Manual page 95

5. PARAMETERS
Class No. Symbol
18 * Status display selection
DMD
Used to select the status display shown at power-on.
19 *BLK Parameter block
Used to select the reference and write ranges of the parameters.
Operation can be performed for the parameters marked
(Initial
value)
Name and function
0 0
Selection of status display at
power-on
0: Cumulative feedback pulses
1: Servo motor speed
2: Droop pulses
3: Cumulative command pulses
4: Command pulse frequency
7: Regenerative load ratio
8: Effective load ratio
9: Peak load ratio
A: Instantaneous torque
B: Within one-revolution position low
C: Within one-revolution position high
D: Load inertia moment ratio
E: Bus voltage
Status display at power-on in
corresponding control mode
0: Depends on the control mode.
Control Mode
Position/internal speed
Internal speed
1: Depends on the first digit setting of this parameter.
Set parameters
Operation
value
to No. 19
0000 Reference
Write
Reference No. 19 only
000A
Write No. 19 only
Reference
000B
Write
Reference
000C
Write
Reference
000E
Write
Reference
100B
Write No. 19 only
Reference
100C
Write No. 19 only
Reference
100E
Write No. 19 only
Position
Cumulative feedback pulses/servo motor speed
Basic Expansion
parameters 1 parameters 2
No. 0 No. 20
to No. 49
5 - 10
Initial
Unit
value
0000
Status display at power-on
Cumulative feedback pulses
Servo motor speed
0000
.
Expansion
No. 50
to No. 84
Setting Control
range mode
P S
Refer to
Name
and
function
column.
P S
Refer to
Name
and
function
column.