(3)
Release the harness from the harness clamp
and slide the pickup solenoid with the spring
upward to take it off.
Note:
When installing the bypass pickup solenoid,
be sure to place the spring between the arm
and the solenoid.
9.5.9
Bypass pickup clutch / Bypass feed clutch
(1)
Take off the bypass unit.
P.9-10 "9.5.1 Bypass unit"
(2)
Remove 1 E-ring, 1 bushing and 2 screws.
Then take off the 1 bracket and 2 gears.
(3)
Take off the bypass pickup clutch with its
shaft.
e-STUDIO182/212/242
PAPER FEEDING SYSTEM
Spring
Bypass pickup solenoid
Gear
Bushing
E-ring
Bypass pickup clutch
© 2009 TOSHIBA TEC CORPORATION All rights reserved
9 - 16
Fig. 9-24
Gear
Bracket
Fig. 9-25
Fig. 9-26