Fuser Roller; Pressure Roller - Toshiba e-STUDIO182 Service Manual

12.6.7

Fuser roller

(1) Take off the center heater lamp and the side
heater lamp.
P.12-19 "12.6.6 Center heater lamp / Side
heater lamp (LAMP1/LAMP2)"
(2) Take off the separation fingers.
P.12-18 "12.6.5 Separation finger"
(3) Take out the fuser roller upward.
Notes:
• When installing the fuser roller, slide each
bushing on both edges of the roller
outward so that the bushings will engage
with the frame and the installation will be
secured.
• Do not apply force onto the roller because
it may be deformed.
(4) Remove 1 C-ring and 1 bushing on the front
side of the fuser roller.
(5) Remove 1 C-ring, 1 gear and 1 bushing on
the rear side of the fuser roller.
12.6.8

Pressure roller

(1) Take off the pressure roller unit.
P.12-14 "12.6.2 Pressure roller unit /
Fuser roller unit"
(2) Remove 3 screws, and then take off the
fuser unit entrance guide.
e-STUDIO182/212/242
FUSER / EXIT UNIT
Bushing
C-ring
Fuser unit entrance guide
© 2009 TOSHIBA TEC CORPORATION All rights reserved
12 - 20
Fuser roller
Fig. 12-28
C-ring
Gear
Bushing
Fig. 12-29
Fig. 12-30