Toshiba e-STUDIO182 Service Manual page 84

(C) Misfeed in equipment
• Exit sensor detects jamming of the leading edge of paper.
Registration clutch ON
Less than regulation time
Exit sensor ON
If the exit sensor is not turned ON after
regulation time
Paper jam (E01)
stopped.
• Exit sensor detects jamming of the tailing edge of paper.
Registration clutch OFF
Less than regulation time
Exit sensor OFF
If the exit sensor is not turned OFF after
regulation time
Paper jam (E02)
stopped.
• Immediately after the power ON
Any of all sensors on paper transport path detects paper (ON)
Paper jam (E03)
• Front cover is opened during copying
Paper jam (E41)
• The registration sensor (S4) is not turned ON in a fixed period of time when paper is fed out of the
ADU.
Paper jam (E11)
e-STUDIO182/212/242
GENERAL OPERATION
The copying operation is
The copying operation is
Registration clutch
Exit sensor
Timer
Registration clutch
Exit sensor
Timer
© 2009 TOSHIBA TEC CORPORATION All rights reserved
4 - 8
ON
ON
0
Regulation time
Paper jam (E01)
Fig. 4-1
OFF
ON
0
Regulation time
Paper jam (E02)
Fig. 4-2