Sram Board (Sram); Fuse Pc Board (Fus) - Toshiba e-STUDIO182 Service Manual

2.6.2

SRAM board (SRAM)

(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Release 1 lock support and take off the
SRAM board.
Notes:
1. Be sure to perform "08-388" after the
SRAM board has been replaced.
2. Perform "05-310" with the platen cover
and the ADF/RADF closed after replacing
the SRAM board.
3. Make sure that the direction of the battery
on the SRAM board is correct when
replacing it.
2.6.3

Fuse PC board (FUS)

Note:
This fuse PC board is copacked with the damp heater unit. (The damp heater unit is optional for
NAD, CND and MJD.)
(1) Take off the rear cover.
P.2-21 "2.5.10 Rear cover"
(2) Remove 2 screws and take off the cover.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Fig. 2-25
SRAM board
Battery
Fig. 2-26
Cover
Fig. 2-27
2 - 23
SRAM board
e-STUDIO182/212/242
OUTLINE OF THE MACHINE
2