(3)
Remove 2 springs.
Note:
When installing the spring, be sure to hang
the spring on the upper hook.
(4)
Take off each 1 pressure lever on both front
and rear sides.
(5)
Take off 2 bushings and then take off the
pressure roller while sliding the pressure
roller to the rear side.
Notes:
•
Do not drop the pressure roller when you
lift it up because it is quite heavy.
•
Be sure to install the pressure roller from
the rear side (pressure roller ground plate
side) in order not to deform the pressure
roller ground plate.
© 2009 TOSHIBA TEC CORPORATION All rights reserved
Spring
Fig. 12-31
Fig. 12-32
Bushing
Pressure roller
ground plate
Fig. 12-33
12 - 21
Pressure lever
Pressure roller
Bushing
e-STUDIO182/212/242
FUSER / EXIT UNIT
12