Polaris RZR XP 1000 Service Manual page 105

7. Install the Clutch Center Distance Tool (PU-50658)
onto the crankshaft
properly position the clutch center distance. The
pictures below show the tool (PU-50658) properly
installed .
8. Loosen the two bolts
bracket to the transmission on the right side.
9. Align the front transmission mounting holes with
transmission joint bracket mounting holes on engine.
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
and transmission input shaft to
retaining transmission joint
© Copyright 2014 Polaris Industries Inc.
ENGINE / COOLING SYSTEM
10. Install the two bolts
bracket to the engine on the right side. Hand tighten
the bolts so they remain loose at this time.
NOTE: DO NOT torque fasteners at this time.
11. Install the two longer bolts into left side mounting
holes. Torque left side mounting bolts to specification
using the numbered sequence shown.
12. Torque right side mounting bolts to specification
using the numbered sequence shown.
Engine / Transmission Mounting Bolts:
Step 1-2: 64 ft-lb (87 Nm)
Step 3: 5 ft-lb (7 Nm)
Step 4-7: 44 ft-lb (60 Nm)
13. Remove the clutch center distance tool.
retaining the transmission joint
3.29
3