Rear Prop Shaft Removal Xp 4 - Polaris RZR XP 1000 Service Manual

FINAL DRIVE
7. Torque the support
specification.
Support Bearing Fasteners:
35 ft-lb (47 Nm)
8. Align the front propshaft paint mark with the front
gearcase input shaft mark so the pin holes align.
Install a new roll pin.
7.26
bearing fasteners to
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.

Rear Prop Shaft Removal XP 4

1. Remove all seats.
2. Remove the front and rear center consoles (see
Chapter 10 – Rocker Panels, Rear Console and
Floor XP 4, page 10.24).
3. Remove the fasteners
plates .
4. Remove center and rear skid plates.
5. Remove the fasteners
bearing cover to the frame.
6. Move the prop shaft support bearing assembly to the
drivers side to slide the rear prop shaft yoke
transmission output shaft.
from center and rear skid
1
securing the support
off the