All Wheel Drive Coil; Operation Overview; Diagnosing System Failures - Polaris RZR XP 1000 Service Manual

Hide thumbs Also See for RZR XP 1000:

Table of Contents

ALL WHEEL DRIVE COIL

• When the key switch is "ON", 12 VDC power is

present at the hub coil.

• When the AWD switch is "ON", and if the criteria is

met, the Engine Controller provides a ground path

(brown/white wire). When this occurs the AWD

icon should display in the instrument cluster.

• The AWD system must be grounded to operate.

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

• Verify the AWD switch is functional and that a

minimum of 11 volts is present at the hub coil.

• Verify the AWD hub coil is functional. Test the

AWD hub coil using an ohm meter. See

specifications below:

AWD Hub Coil Resistance:

• Verify the wiring harness, wiring, connectors,

connector pins and grounds are undamaged,

clean and connect properly.

• Verify continuity of wire connections with a known

good volt/ohm meter.

NOTE: Verify all wires and wiring connections

have been tested properly with a known good

component failure. 80% of all electrical issues

are caused by bad/failed connections and

Table of Contents

Rzr xp4 1000