Rear Trailing Arm; Trailing Arm Removal / Installation - Polaris RZR XP 1000 Service Manual

Hide thumbs Also See for RZR XP 1000:

Table of Contents

STEERING / SUSPENSION

REAR TRAILING ARM

NOTE: Use new attaching nuts upon installation of

the rear trailing arm and bearing carrier.

1. Raise and support vehicle by main frame.

Serious injury may result if machine tips or falls. Be

sure machine is secure before beginning this service

2. Remove the four wheel nuts and remove the rear

3. Remove the cotter pin

hub castle nut

. Remove the nut, and two cone

from the rear wheel hub assembly.

4. Remove the lower radius rod mounting bolt

and washer from the bearing carrier. Swing radius

rod down. Discard the nut.

5. Remove the two brake caliper mounting bolts

and loosen the rear wheel

9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual

6. CAUTION: Do not hang the caliper by the brake line.

Use wire to hang caliper to prevent damage to the

7. Remove the rear wheel hub and brake disk

8. Remove the five remaining bolts

rear bearing carrier to trailing arm. Discard the nuts.

that attach the

Table of Contents

Rzr xp4 1000