Panasonic UF-6300 Service Manual page 120

Code Mode Phase
409 XMT
410 RCV
411 RCV
(Polling)
412 G3 RX
414 RCV
(Polling)
415 XMT
(Polling)
416 RCV
417 RCV
418 RCV
420 RCV
421 RCV
422 XMT
427 G3
RCV
433 XMT
RCV
434 XMT or
RCV
436 G3 RX
Fax Information Codes
Description of Problem
D Transmitter receives PIN after it
transmitted a post message, such
as EOP, MPS, EOM, etc.
D Received DCN while waiting for
post command. (EOP, MPS, EOM,
etc.)
B Received DCN after transmitting
NSC.
B, D No response within 12 seconds in
NSS/DCS/MPS wait state. (After
transmitting FTT)
B No response received after
transmitting 3rd NSC.
B Remote side attempted to receive
message from your machine in
polling communication.
D Receiver did not detect post
command, such as EOP, MPS,
EOM, etc.
C Receiver returned RTN in response
to post message.
C Receiver transmitted PIN in
response to PRI-Q from transmitter.
(Transmitting operator requests
voice contact)
B T1 timer (35 sec.) elapsed without
detecting 300 bps signal.
B Busy Tone is detected after sending
NSF Signal.
B Content of NSF (or DIS) or NSC (or
DTC) was invalid.
B DCN received to NSF/CSI/DIS
transmitted.
B, D T.30 Protocol abnormal.
B CD (response from Modem) did not
turn OFF within 180 sec. after
receiver detected FLAG signal.
C DCN received after transmitting
FTT.
Receiver receives data with error due to
poor line quality, and receiving operator
requests voice contact.
Receiver is defective. (Modem, etc.)
SC PCB or MJR PCB are defective.
Interface or line is faulty.
Transmitter is defective.
Transmitter is not ready for polling
communication.
Password does not match between
transmitter and receiver.
Transmitter is defective.
SC PCB is defective.
Password does not match between
transmitter and receiver.
Transmitter is defective. (No original,
document jam, etc.)
Inform the remote side that your
machine does not have the polling
transmission feature.
Transmitter is defective.
Line quality is poor. (RTC signal is
distorted due to line noise)
SC PCB or MJR PCB are defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or MJR PCB are defective.
Line quality is poor. (There are
excessive errors in received data)
SC PCB or MJR PCB are defective.
There is wrong incoming call.
(non-facsimile communication)
Transmitter is defective.
SC PCB or MJR PCB are defective.
Remote station disconnected the line.
Wrong number is dialed.
There is an incompatibility.
The interface is incompatible.
Defective remote station.
Remote unit is defective.
SC PCB or MJR PCB are defective.
Transmitter is defective or incompatible.
Line quality is poor.
120
Cause