Panasonic UF-6300 Service Manual page 163

5.1.5. Service Mode 5 (Diagnostic)
5.1.5.1. CCD Test
This Service Mode is used to check the CCD.
Use the following procedure to initiate the test.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "5".
Press "START".
5
The Scanner will be active.
6 Press "STOP" twice to return to standby.
5.1.5.2. LCD / LED Test
This Service Mode is used to check the LCD and LEDs on the Control Panel.
Use the following procedure to initiate the test.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "5".
Press "2" and "START".
5 1) LCDs display as shown at right.
2) All LEDs will be lit.
6 Press "STOP" twice to return to standby.
Service Mode 5
Operation or Unit Condition
Service Mode 5
Operation or Unit Condition
163
LCD Display
MMM-dd-yyyy 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
DIAGNOSTIC (1-3)
1:CCD TEST
1:CCD TEST
* CHECK NOW *
MMM-dd-yyyy 15:00
00%
LCD Display
MMM-dd-yyyy 15:00
00%
SET MODE (1-6)
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
DIAGNOSTIC (1-3)
1:CCD TEST
2:LCD/LED TEST
* CHECK NOW *
MMM-dd-yyyy 15:00
00%