Panasonic UF-6300 Service Manual page 165

5.1.7. Service Mode 7 (LBP Service Mode)
This Service Mode is used to change printer parameters and verify printer information.
Use the following procedure to change printer parameter.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "7".
1) Press "START" for printer parameter settings.
5 Press "2" and "START" to get the printer information.
Ex: Enter "START" for printer parameter settings.
Press "3" and "START".
6 Then enter the number of pages.
Ex: Enter "50" and press "START".
Press "\/" or "/\" to select another Parameter Name (See Table) or
7
press "CLEAR" to return to step 4.
Repeat step 5 through 7 to request operation, or press "STOP" twice
8
to return to standby.
Sub-Code
1 PRINTER COUNTER
1 2 LBP FUSER RESET
3 OUT OF TONER
\/ /\ PRINT AVAILABLE
2
\/ /\ LBP MEMORY CAPACITY Shows the Page Memory Capacity.
Operation or Unit Condition
Parameter Name
Service Mode 7
Displays and resets the Printer and Paper Cassette(s)
counters.
Clears the LBP Fuser Error.
Sets the number of pages to print after low toner is
detected. (Factory default = 100, adjustable from 0 - 999)
Shows the remaining number of allowable printable pages
after low toner has been detected (Counter Only).
165
LCD Display
MMM-dd-yyyy
SET MODE
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
LP SERVICE MODE (1-2)
1:LBP PARAMETER SET
LBP PARAMETER SET
1.PRINTER COUNTER
LBP PARAMETER SET
3.OUT OF TONER
LP SERVICE MODE (1-2)
1.LBP PARAMETER SET
MMM-dd-yyyy
Description
15:00
00%
(1-6)
15:00
00%