Panasonic UF-6300 Service Manual page 33

2.2.4. Transmit Guide (301) Assembly, Scanning Glass (308)
(5)
(3)
(7)
(7) Remove 5 Screws (19).
(8) Remove the Control Panel Chassis Assembly, and
Front Panel.
Note:
If noise occurs while scanning, clean the Roller Shaft
2 (235), and the Feed Pinch Roller (236) shaft hole
with isopropyl alcohol.
(9) Remove 15 Screws (19).
(10) Disconnect Connector CN50 on the PNL1 PC
Board.
(11) Release 2 Latch Hook.
(12) Remove the PNL1 PC Board (1004).
(1) Remove the Left Cover (103), Right Cover (102),
(4) x 4
and Front Cover (104) (Refer to 2.2.2.).
(2) Remove the Control Panel Unit (Refer to 2.2.3.).
(3) Release the Harnesses from the clamps.
(4) Remove 4 Screws (19).
(5) Disconnect 4 Connectors (CN1, 3, 5, and 7) on the
SC PC Board.
(6) Remove the Transmit Guide (301) Assembly.
(6)
(7) Carefully release the Latch Hook using a Blade-tip
Screwdriver.
(8)
(8) Remove the Scanning Glass (308).
33