Panasonic UF-6300 Service Manual page 42

(10)
2.2.13. MJR PC Board (1003), Power Supply Unit (1002)
(10) Remove 2 Screws (4N).
(11) Remove the Printer Motor (626).
(11)
Caution:
Make sure the Power Cord (1108) is unplugged.
Note:
If removing only the Power Supply Unit, skip steps
(4), (5), and (6).
(1) Remove the Rear Cover (105) (Refer to 2.2.12.).
(2) Release the Harness from the Clamp.
(3) Disconnect the Connector on the MJR PC Board.
(4) Remove 2 Screws (C8).
(5) Remove the MJR PC Board (1003).
(6) Remove 5 Screws (C8).
(7) Remove the L Power Plate (401).
(8) Disconnect the Connectors (CN32, 101, 102, 103,
201, and 202) on the Power Supply Unit (1002).
(9) Remove 1 Screw (19), and 1 Washer (G8).
(10) Remove 1 Screw (19), and 1 Harness.
(11) Remove other 3 Screws (19).
(12) Remove the Power Supply Unit (1002).
Caution:
When reinstalling, make sure the Harnesses are not
nipped.
42