Panasonic UF-6300 Service Manual page 216

<Replacing the Directory Sheet>
(11) Replace the preinstalled Directory Sheet to the desired language.
Note:
Alphabet arrangement is dependent on the destination, and may differ.
(12) Plug the AC Power Cord first, then reconnect the Telephone Line Cable.
(13) Connect the LAN Cable.
(14) Install the Internet Fax Software into the PC by following the prompts of the Installation Wizard. For
details, refer to the Operating Instructions (For Internet Fax).
(15) Proceed the communication test to ensure the Internet Fax Option works properly.
Note:
When this option is installed, "Energy Saver" mode is automatically set, and "Sleep" mode is not
available.
(5) Remove the Speaker Harness from CN9.
(6) Cut off the protective tab on the LAN Jack on the Left
Cover.
(7) Attach the LAN Label and RX-LINK Label to the Left
Cover as illustrated.
(8) Remove 1 Screw (Lower).
(9) Install the LAN PC Board into CN93 on the SC PC
Board, and secure with 1 Screw and 1 Tapping
Screw (M3 x 8).
Note:
Use 1 preinstalled Screw by removing from Lower
position, and secure it as illustrated.
(10) Reinstall all Harness and Covers.
216