Panasonic UF-6300 Service Manual page 210

No. Parameter
133 JOB BUILD
135 JUNK FAX
FILTER
136 RESTRICT D.
DIAL
137 RE-ENTER D.
DIAL
Setting
Setting
Number
1 OFF
2 ON
01. JUNK FAX FILTER When set to "VALID", the machine will not receive the
1 INVALID
2 VALID
02. RCV WITHOUT ID When set to "VALID", the machine will receive faxes from
1 INVALID
2 VALID
03. RECEIVED ID
PRINT
1 INVALID
2 VALID
04. ID NO. REGIST.
(NO. 01-30)
1 INVALID
2 VALID
1 INVALID
2 VALID
Selecting whether the machine performs Job Build when
the total number of documents exceeds the maximum
capacity of the ADF, or when scanning the documents
manually one at a time. If you place the documents on
the ADF within 5 seconds after the ADF scan, the ADF
scan will continue for the current scan. (Maximum
number of scanning sheets is 255 pages for one job.)
The Quick Memory Transmission feature (Fax Parameter
No. 82) is not available when the Job Build is set to
"2:ON".
Up to 250 pages can be stored. When the number of
pages exceeds 255, the memory overfull message will be
displayed. Select "Yes" to start transmitting, or "No" to
cancel.
If no action is taken within 5 seconds, the machine will
start transmitting the stored originals.
Function to prevent direct mail FAX and unnecessary
FAX messages.
faxes from the senders whose numeric ID has been
registered as a junk fax number. The denied number IDs
can be registered in "04.ID NO. REGIST.".
senders without numeric ID registered.
(This setting is available only when "01. JUNK FAX
FILTER" is set to "VALID".)
When set to "VALID", the sender's numeric ID and
received time are printed at the bottom of the received
faxes. If the sender's numeric ID is not registered, only
the received time is printed.
(This setting is available only when "01. JUNK FAX
FILTER" is set to "VALID".)
Register fax numbers as junk fax number.
Up to 30 fax numbers can be registered for junk fax
number. (Including numerals "0-9", blank space, and +
symbol.) (When comparing the sender's numeric ID to
the registered junk fax numbers, blank spaces between
numbers are ignored.)
Enable or disable the Restrict Direct Dial function.
When set to "VALID", manual input destination Tel No.
and "Redial" button are not accepted.
Used to set whether to display the address reinsert
screen when indicating the address for direct dial,
inputting the mail address for Internet FAX, redialing or
inputting the address for confirming the address. When
set to "VALID",
unit will require input destination Tel No. or Mail address
twice for confirmation. Unit will proceed transmit job when
destination data is matched.
This setting is not available when the Restrict Direct Dial
function is set to "VALID".
210
Comments