Panasonic UF-6300 Service Manual page 155

5.1.3.5. Protocol Trace
Print a Protocol Trace Report for the previous communication.
Step
1 Standby
2 Press "FUNCTION" and then "7".
3 Press "MONITOR" four times, then press "*".
4 Press "3".
Press "6" and "START".
Note:
5
If there were no transmission or reception mode after the power is
last turned on, you cannot print the Protocol Trace Report.
6 After printing is completed, the unit returns to the display in step 3.
7 Press "STOP" to return to standby.
*************** PROTOCOL LOG REPORT ****************** DATE MMM-dd-yyyy ***** TIME 16:56 ***P.01
************************************ -PANAFAX
Service Mode 3 - Protocol Trace
Operation or Unit Condition
STATUS : OK
MODE : ECM-TX (STANDARD)
SPEED : 9600bps
REMOTE CAPA. : DIS 00 CE B9 C4 80 12
LOCAL CAPA. : TSI 2B 20 20 20 38 37 2B 2B 2B 2B
39 38 36 36 35 34 37 38 38 30
DCS 00 C6 F8 44
COMMAND LOG.
REMOTE : NSF CSI
LOCAL :
------------------------------------------------------------------
REMOTE : MCF
LOCAL : DCN
00MS/L
DIS CFR
TSI DCS
-PANASONIC-
- ***********-12345678901234567890-******
155
LCD Display
MMM-dd-yyyy
SET MODE
ENTER NO. OR
SERVICE MODE
ENTER NO. OR
PRINTOUT (1-7)
1:FUNC. PARAM. LIST
* PRINTING *
PROTOCOL TRACE
SERVICE MODE
ENTER NO. OR
MMM-dd-yyyy
PIX PPS-EOP
15:00
00%
(1-6)
15:00
00%