NEC univerge sv8100 User Manual page 369

2.
3.
Programming Incoming Ring Group Overflow
1.
2.
3.
Programming DID Overflow
1.
2.
InMail System Guide
Assign InMail as the overflow (no answer) destination.
22-08-01 DIL/IRG No Answer Destination
For each trunk assigned as a DIL above, enter the InMail Department
Group pilot number to make InMail the overflow (no answer) destination.
By default, the overflow (no answer) destination is Incoming Ring Group 1.
.
Set the interval after which unanswered calls should route to the overflow
destination.
22-01-04 DIL No Answer Recall Time
Enter the interval after which unanswered calls should overflow to the
programmed overflow (no answer) destination.
By default, this interval is 0 (no overflow).
.
Set up the Incoming Ring Group trunks.
22-02-01 Incoming Call Trunk Setup
Assign Service Type 0 (Normal) to each Incoming Ring Group trunk. Make
a separate entry for each Night Service mode.
By default, trunks are Service Type 0 (Normal).
.
Assign InMail as the overflow (no answer) destination.
22-08-01 DIL/IRG No Answer Destination
For each trunk assigned as an Incoming Ring Group trunk above, enter the
InMail Department Group pilot number to make InMail the overflow (no
answer) destination.
By default, the overflow (no answer) destination is Incoming Ring Group 1.
.
Set the interval after which unanswered calls should route to the overflow
destination.
22-01-04 DIL No Answer Recall Time
Enter the interval after which unanswered calls should overflow to the
programmed overflow (no answer) destination.
By default, this interval is 0 (no overflow).
.
Set up the Incoming Ring Group trunks.
22-02-01 Incoming Call Trunk Setup
Assign Service Type 3 (DID) to each Incoming trunk. Make a separate entry
for each Night Service mode.
By default, trunks are Service Type 0 (Normal).
.
Assign InMail as the overflow (no answer) destination.
Issue 7.00
2 - 361