NEC univerge sv8100 User Manual page 384

Issue 7.00
3 - 376
Keys for Entering Names
When entering names in the procedures below, refer to this chart. Names can be up to
12 digits long.
Use this keypad
digit . . .
Enter characters:
1
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
2
Enter characters: D-F, d-f, 3.
3
Enter characters: G-I, g-i, 4.
4
Enter characters: J-L, j-l, 5.
5
Enter characters: M-O, m-o, 6.
6
Enter characters: P-S, p-s, 7.
7
Enter characters: T-V, t-v, 8.
8
Enter characters: W-Z, w-z, 9.
9
Enter characters:
0
0
Enter characters:
Q
Q
# # = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Clear the character entry one character at a time.
Conf
Clear all the entries from the point of the flashing cursor and to the
Hold
right.
Options
Characters (12 maximum, using upper and lower case letters).
Use a space or comma as the delimiter between the first and last name.
Default
No extension names entered.
Key for Entering Names
When you want to. . .
! " # $ % &
+ , - . / : ;
→ ←
Á À Â Ã Ç É Ê ì ó
) ô Õ ú ä ö ü α ε θ
' (
Π Σ
< = > ?
Programming
Ζ
σ
¢ £