NEC univerge sv8100 User Manual page 393

InMail System Guide
Keys for Entering Names
When entering names in the procedures below, refer to this chart. Names can be
Use this keypad
digit . . .
Enter characters:
1
1 @ [ ¥ ] ^ _ ` { | }
Enter characters: A-C, a-c, 2.
2
Enter characters: D-F, d-f, 3.
3
Enter characters: G-I, g-i, 4.
4
Enter characters: J-L, j-l, 5.
5
Enter characters: M-O, m-o, 6.
6
Enter characters: P-S, p-s, 7.
7
Enter characters: T-V, t-v, 8.
8
Enter characters: W-Z, w-z, 9.
9
Enter characters:
0
0
Enter characters:
Q
Q
# # = Accepts an entry (only required if two letters on the same key
are needed - ex: TOM). Pressing # again = Space. (In system
programming mode, use the right arrow soft key instead to accept
and/or add a space.)
Clear the character entry one character at a time.
Conf
Clear all the entries from the point of the flashing cursor and to the
Hold
right.
47-01-03 Subscriber Message Length (Subs Msg Length)
Use this option to set the maximum length of recorded messages for:
Subscriber Mailbox users dialing RS to record and send a message.
Extension users leaving a message in a Subscriber Mailbox.
Outside Automated Attendant callers accessing a mailbox via a GOTO
command and then dialing RS (77) to record and send a message.
Key for Entering Names
up to 12 digits long.
When you want to. . .
! " # $ % &
+ , - . / : ;
→ ←
Á À Â Ã Ç É Ê ì ó
' ( ) ô Õ ú ä ö ü
Π Σ σ Ζ
< = > ?
Issue 7.00
α ε θ
¢ £
3 - 385